Tutorials
The video above applies to all the CR-10 variants, however since the video was made, several revisions have been made. Below are quick dynamic examples of those revisions.
Filament Sensor (just a quick visual)
For the CR-10S, S4 and S5 and upgraded CR-10. Plug in the unmarked cable to the filament sensor.
Filament Sensor V2 (LERGE Filament Sensor)
For the 300 Super+ and others.
Dual Z Tips
For the CR-10S, S4 and S5 or CR-10 machines with the Dual Z Upgrade. This is a maintenance routine.
To make sure there is zero binding, make sure all the wheels on the Z axis turn with slight drag.
The brass nut is supposed to be left loose so the lead screw can float some turning operation.
After Setup
Video guide for Babystepping
BL TOUCH SETUP GUIDES
You can can verify which ABL strategy your machine is in by finding "About Printer" in the main menu then selecting Printer Info."
Bilinear Setup for BL Touch (Universal)
Unified Bed Leveling
UBL Setup for BL Touch (Creality)
UBL Setup for BL Touch (Formbot)
Other Guides
S4/S5 Lightweight Carriage Install
Simplify 3D Quick Start Guide
Support Rod Install (Creality)
If you purchased the Drop-In Micro Swiss Hot End, follow this video for installation help.
Dual Z Install for CR-10 and older CR-10/S4
If you purchased the Dual Z kit from us (or anywhere), follow this video for installation help.
To replace a bad motherboard or upgrade to one with a bootloader, follow this video for installation help.
CR-10 to CR-10S Electronics Upgrade
If you purchased this electronics upgrade from us, follow this video for installation help.